Preparation:

1. No stone and sharp objects then put the ground sheet.

2. Keep flat of the product without any cross and tie the line of the tent or the arch.

3. Products need to be spread out as large as their sizes, ie. the arch of 15meters must be spread out as 15meters span.

Inflating:

1. When the product is nearly stand up, someone along with the two sides should push it into center to stop the tent being inflated to outside.

Meanwhile, 2 or more people support the product with smooth objects in the middle to help it totally stand up.

2. It is not better to pump it with too much air , 90% saturation is ok.

It’s ok if it is possible, deflate slightly when meets high temperature at noon

or strong sunshine and inflate properly when temperature gets lower in the afternoon.

This is very important!!!

Inflated:

1. When finish inflating, fix the top of tent or arch with stakes, make them to be symmetrical in order to prevent strong wind to damage the tents and arches.

Maintenance:

1. If broken, please glue the broken part once or twice, and dry it with electronic dryer, then cut one circle or strap material with glue on once or twice,

which is bigger than the broken part, make it dry and glue on the broken part, and keep it flat, after that, inflate and use the product till the glue is completely dry.

It’s better to be used after 48 hours later.